Network Sensors: Quick Reference Guide

Introduction

This document provides quick reference information about our network sensors. A printable PDF version of the document is also attached to this article. 


Choose a sensor

Choose a sensor based on the number of endpoints and the amount of network traffic at the site.


Sensor

Max endpoints

Max bandwidth

Deployment mode

Compact One (C1)

NA

250 Mbps

Port-mirrored only

Business One (B1)

500

250 Mbps

Port-mirrored or inline

Enterprise One (E1)

1,500

1 Gbps

Port-mirrored or inline

Enterprise 100 (E100)

10,000

5 Gbps

Port-mirrored or inline


Identify your sensor in the portal

Each sensor model appears in the Field Effect portal under a different identifier. Use the table below to match a physical sensor to its portal entry.


Sensor

Identifier

What to look for in the portal

Example

Compact One (C1)

Serial number

The serial number

7J1609700100179

Business One (B1)

MAC address

M followed by the last 6 characters of the MAC address

MF1B2C3

Enterprise One (E1)

Service Tag

The Service Tag

K5F9GCH

Enterprise 100 (E100)

Service Tag

The Service Tag

K5F9GCH


To view sensor serial numbers,

  1. Log into the MDR Portal and navigate to the Status page.
  2. Expand the Network Monitoring Section
    1. If you are a partner, ensure the organization is set to appropriate client.


Connect the sensor

Sensor ports are color-coded. Which ports you need depends on your deployment mode.


Port color

Port-mirrored

Inline

Purpose

Green

Required

Required

Management

Yellow

Required

Required

Traffic in

Blue

Not used

Required

Traffic out (inline only)

Red

Optional

Optional

Static IP management


  • Green: Connect to an internal switch. The sensor uses this port for backup and managed service connectivity. It gets its IP address from the LAN through DHCP. We recommend creating a DHCP reservation for it.
  • Yellow:
    • In a port-mirrored deployment, connect to a SPAN port.
    • In an inline deployment, connect to the WAN. This is the inbound connection to the sensor.
  • Blue: In an inline deployment, connect to the LAN port or core network switch.
  • Red: Use this port instead of the green port if the management connection needs a static IP address. Configure the IP address, subnet, default gateway, and DNS in the management console.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article